Publicidad
Idiomas disponibles
Idiomas disponibles
GT2701
7.2. Pen Display Setting
Select the Working Area tab to adjust the ratio of the distance of pen movement on the pen
display to that of the corresponding cursor movement on the monitor. By default, the entire
active area of the pen display maps to the whole monitor.
If more than one monitor is in use and they are in extended mode, users need to choose one that
will be mapped to on the driver interface and the other one as the external display.
In mirror mode (All monitors display the same content), the pen display maps to the entire screen
on each monitor and cursors displayed on them move simultaneously.
7.2.1. Working Area Setting
Define the pen display area that will be mapped to the monitor. Three modes on the driver can
be chosen:
[1] Full Area: The entire active area of the pen display will be mapped to the monitor. It is the
default setting.
[2] Screen Ratio: The ratio of the active pen display area is the same as that of the monitor, which
as a general rule, is 16:9. For example, if you choose the screen ratio and draw a circle on the pen
display, then a circle appears on the monitor that has been connected to the pen display, in this
case some parts of the pen display may not work. But if you don't choose the screen ratio and
draw a circle, then the circle may change into an oval on the monitor.
The ratio of the active pen display area depends on that of the display device, which as a general
rule. In Screen Ratio mode, these two ratios keep the same.
[3] Custom Area:
1> Enter coordinate values.
2> Users can adjust the working area of the pen display by changing the outlines of the smaller
www.huion.com
26
Publicidad
