WARNING
ElectricalShock Hazard
Unplug power cord from electrical outlet,
Do not operate the cleaner without the
or exhaust filters. Be sure the
' installedto
PRIMARY FILTER
Check primary filter frequently
and clean
when dirty.
TO REMOVE
PRIMARY
FILTER
Remove the dust bin and dust bin lid
assembly as outlined in the DUST BIN
CLEANING
section. While holding the pri-
mary filter over a trash container
grasp filter,
rotate and lift off.
Clean primary filter by
Filter-.
gently tapping over a trash
container_
Locking
Tab
Tap on several
sides to
ensure best
cleaning.
Cover
Slot
Rinse with water only as needed (see Dust
Bin Cleaning).
When cleaning the filter no longer restores
vacuum suction to full power you need to
replace the filter.
TO REPLACE
PRIMARY
FILTER
Make sure that the slots
of the filter line up with
Filter_
/_;4:_._,_k
the locking tabs on the
_i,7,..
)
filter cover. Replace filter
"_ "_//
and rotate filter until
_.
_.\_
slots look onto tabs
_"_
in cover.
Filter.lV'_
"_
_
Slot
Cover
_
_J
"__/"
Locking
Tab
Note: Under normal use and care, your filter
can be expected
to last up to 3 years.
Re-attach the filter cover and filter to dust
bin (see Dust Bin Cleaning).
Place dust bin
back into cleaner.
EXHAUST FILTER
ELECTROSTATIC
The exhaust filter must be replaced
when
dirty.
It should be replaced
regularly
depending
on use conditions.
The filter CANNOT be washed as it will lose
its dust trapping ability.
Press inward on each side of
I _"--
exhaust filter cover and pull out /
=
to remove from vacuum
Press
cleaner.
Inward
Exhaust
Filter
C_f_
Remove the frame and filter.
Exhaust
Replace the
exhaust filter,
carefully position-
ing it so that it fits
into the frame.
The white side
of the filter
should be fac-
ing towards the
operator.
Filter
Frame
Filter
/
White Side
Out
Exhaust
Filter
Cover
Replace the
exhaust filter
cover by plac-
ing tabs in
slots and push-
ing in until
cover snaps
into place.
15