Publicidad
Idiomas disponibles
Idiomas disponibles
:::::_:::::_ i!!!!!! i i!!!!!! !;:i ¸ i iilii i "h¸_ i' "":_:i:!:!: !:!:!:!:!! i:E '_ :.: " :':i:_:ii_:i:.:_!i:i:
:ii: .i:i:i::_:_:::i:!:i:i
_.:y:i:;:i::_:i:i:!:!i_:i
i:'_i ::i:'_':y:':_:_:_:"
:i:i:.:: _:,:.: :': : :::i::_ ¸':_.i.i. :,::: _ :i_._'_'_::;_
,,_:_.: :.:._ :" i.i_i: ' i i::i :: ::::" '_" :':if!_ ::::::::::':::i iiiii ::::::_i:_:!:
ii i i:I
I
SOME
MODELS
Bare floor setting: Slide the carpet/bare
floor
selector all the way back and down toward
the bottom of the nozzle until it locks into
place.
In this position the brush assembly
does not
revolve. This setting should be used
for
cleaning hardwood
and tile floors and when
any attachments (tools) are used.
Carpet setting:Slide the selector all the way
forward and up to the carpetposition.
In this position the brush assembly
will turn.
When carpets are being cleaned
the selec-
tor should be in this position.
Attention:
Refer to your carpet manufactur-
ers cleaning recommendations.
Some more
delicate carpets may require that they be
vacuumed
with the agitator turned off, to
prevent carpet damage.
r= . CAUTION
Do not allow vacuum cleaner to remain
in one spot for any length of time when
the agitator Is turning.
Damage to carpet
may occur.
NOTE:
For longer belt life, turn vacuum off
before moving selector.
Failure to do so can
cause the belt to rub on the selector
shaft
and may result in the belt becoming
hot and
creating a burning rubber smell.
Carpet/Bare
Floor Selector
To Bare Floor
Position
\
To Carpet
Position
Release the handle by placing your foot on
the foot rest and pull back on the handle
until it releases from its upright position.
SOME
MODELS
Release the handle by pressing down on
the handle release pedal with your foot and
pulling back and down on the handle with
your hand.
Foot Rest For
Handle
Release Pedal
To start the vacuum
cleaner, step on the
ON/OFF switch located on the back of the
vacuum.
To stop the vacuum cleaner, step
on the switch a second time.
On/Off
8
Publicidad
