Publicidad
Idiomas disponibles
Idiomas disponibles
Connect Hose and Water Supply to Pump
NOTE:Removeand discard the stlipping cap from the
pump's water inlet before attaching hoses.
1.
Attach end of higil pressure hose without metal
reinforced end to base of spray gun. Tighten by hand.
WARNING
The high pressure stream of water that this
_
quipment produces can cut through skin and its
underiying tissues, ieading to serious injury and
)ossibb amputation,
• NEVERconnect high pressure hoseto nozzle extension.
o Keep high pressure hose cormectedto reel and spray gun while
system is pressurized.
o Always be certain reel, spray gun, nozzles and accessories are
correctly attached.
.
Before connecting garden hose to water inlet, inspect
inlet screen (A). Cleanscreen if it contains debris or
have it replaced if damaged. DO NOT run )ressure
washer if inlet screen is damaged.
/
?
3.
Run water through your garden hose for 30 seconds to
clean out any debris.
iMPORTANT: DO NOTsiphon standing water for the water
suppty. Use ONLYcoid water (less than I O0°F).
4.
Connectthe garden hose (not to exceed 50 feet in
bngth) to the water inlet. Tigistenby hand.
NOTICE
Using a One Way Vaive (vacuum breaker or check vaive)
at pump inlet can cause pump or inlet connector damage.
ThereMUSTbeat leastten feet (3 m) of unrestricted garden
hosebetween the pressure washerinletandan}/' d evice,suchas
a vacuumbreaker o r checkvalve.
Darnage to equipment r esultingfrom failureto follow this
instructionwill voidwarranty.
5.
Turn ONthe water and press red button on spray gun
and squeezetrigger to purge the pump system of air and
impurities.
WARNING
,,_
Risk of eye injury.
_
jSpraycan splash back or propel objects.
Alwayswearsafetygoggles when usingthis equipment o r in
vicinityof whereequipment i s in use.
Beforestartingthe pressurewasher,be sureyouare wearing
adequate safetygoggles.
NEVER substitutesafetyglassesfor safetygoggles.
Checklist Before Starting Engine
Reviewthe unit to ensure you have performed atl of the
foflowing:
1.
Be sure to read Safety Rubs and Operationsections
before using the pressure washer.
2.
Make sure handle and hose reet is in place and secure.
3.
Checkthat oii has been added to proper level in engine
crankcase.
4.
Add proper fuei to fuei tank.
5.
Checkfor proper hose connections (high pressure and
water supply) and that there are no kinks, cuts, or
damageto the high pressure hose.
6.
Provide proper water supply (not to exceed IO0°F).
11
Publicidad
