Identification Data; Technical Description; Intended Use; Safety - Fimap FM33 Manual De Uso Y Mantenimiento

Tabla de contenido

Idiomas disponibles

For technical assistance or to request replacement parts, always give the model, the version and serial number written on the serial number

plate.

This appliance has been built for the professional cleaning of indoor hard vinyl floors, to be carried out by following the instructions. The

appliance must only be used for this purpose.

This appliance was designed and built to be used by a qualified operator to clean smooth, compact flooring in the commercial, residential and

industrial sectors, in proven safety conditions. The appliance is not suitable for cleaning rugs or carpets.

The appliance is only suitable for use in indoor - or at least covered - areas.

ATTENTION: The appliance is not suitable for use in the rain, or under jets of water.

Operator cooperation is paramount for accident prevention. No accident prevention programme can be effective without the full co-operation

of the operator who is directly responsible for machine operation. The majority of occupational accidents that happen both in the workplace or

whilst moving are caused by failure to respect the most basic safety rules. An attentive, careful operator is most effective guarantee against

accidents and is fundamental in order to implement any prevention programme.

The serial number plate is located at the rear of the handlebar, and

indicates the general characteristics of the appliance, in particular

the appliance's serial number. The serial number is a very important

piece of information and should always be provided together with any

request for assistance or when purchasing spare parts.

Working width

Brush diameter

Number of pad holder revs

Brush head motor rated power

Brush head motor nominal voltage

Brush head motor frequency

Maximum gradient with full load

Solution tank capacity (optional)

Rear wheels (diameter / width)

Appliance length

height of the appliance to the brush head carter

Height of the appliance to the shaft

Appliance width

Appliance service weight (without solution tank)

Length of power supply cable (optional)

Sound pressure level (in compliance with IEC 704/1)

Uncertainty K

Hand vibration level

Uncertainty of measurement of vibrations