Publicidad
Idiomas disponibles
Idiomas disponibles
Ysia 5 Zigbee
Ysia 1 Zigbee
1.8.Channel selection on Ysia 5 Zigbee
Before using Ysia Zigbee, check that the correct channel has been selected.
A short press on the channel selector displays the selected channel.
Successive presses change the selected channel.
The LED for each channel from 1 to 4 lights up individually then all the LEDs light up
for the selection of channel 5.
NOTICE
Each channel can be used with different products or group of products.
2.INSTALLATION
2.1.Commissioning with a control point
This chapter describes the commissioning of the drive with a control point, without using the TaHoma pro application.
This configuration is referring to TaHoma ready solution.
For commissioning using the TaHoma pro application, please refer to chapter Commissionning with TaHoma pro.
2.1.1.Introduction
Creation of a network from a control point without TaHoma switch is possible to have a first implementation. This network
will only be accessible to specific compatible products. Each control point creates its own interface with its products in a
unique network of its own.
NOTICE
In the case of several control points in the same installation, the network must first be shared between the new
control points and the existing network to avoid breaking links with already paired products.
2.1.2.Add control points in the installation
If a new control point is needed on the installation (to control the same drive), the
first step is to share the network of the control point(s) already in place with the new
control point.
CAUTION
Move the control point away from the drives to avoid modifying the drives settings with the control point (during
these operations with a control point, the drives must not make any movement).
©
Copyright
2023 SOMFY ACTIVITES SA. All rights reserved.
EN
1
2
5
3
4
5
Publicidad
