Publicidad
Idiomas disponibles
Idiomas disponibles
EN
1] Press and hold the PROG button of the new control point B until the light
turns off (after the third red blink). The control point blinks in orange (see
Feedback LED ergonomics). It is ready to join an existing network.
2] Briefly press the PROG button on the existing control point while A being
close to the new control point, after a few seconds LED lights up green on the
new control point.
g All control points share the same network now.
g If in doubt whether your installation shares the same network, repeat the
procedure above.
2.1.3.Add a drive in the installation
1] Press and hold the PROG button on the drive until the motorised product
moves up and down while being close to the control point:
ð The LED on the drive will begin to blink orange (programming mode).
2] Briefly press the PROG button on the control point:
ð The motorised product briefly moves up and down.
ð The drive is paired with the control point.
NOTICE
If after adding the drive, the motorised product does not move when using the control point, refer to the drive
instructions for the setting procedure.
2.2.Commissioning with TaHoma pro application (recommanded)
CAUTION
Settings are not possible if the control point batteries are too low.
Commissioning with TaHoma pro application is possible and recommended for both TaHoma ready solution
and TaHoma switch solution.
2.2.1.Starting-up
A Somfypro account is required but TaHoma switch is not mandatory.
To set the drive, you need to access and use TaHoma pro application, you must have a compatible phone or mobile device.
The application is downloadable for free from Apple Store platforms and Google Play Store on the following mobile
devices:
®
▪ Apple iPhone
mobile phone or mobile device with iOS operating system running iOS 15.0 and later.
6
1]
2]
1]
2]
©
Copyright
2023 SOMFY ACTIVITES SA. All rights reserved.
Ysia 1 Zigbee
Ysia 5 Zigbee
A
B
B
A
B
A
B
Publicidad
