Levenhuk Ermenrich SLR640 Guia Del Usuario página 4

Specifications
Measuring range
Measuring accuracy
Units of measurement
Laser class
Tape length
Auto-off
Operating temperature range
Power supply
The manufacturer reserves the right to make changes to the product range and specifications without prior notice.
Care and maintenance
This is a class II laser product. Please DO NOT look directly into the beam with unprotected eyes or through an optical device at any time
and never direct it toward other people. Do not remove any safety labels. Do not aim the device directly at the sun. Do not try to disassemble
the device on your own for any reason. For repairs and cleaning of any kind, please contact your local specialized service center. Protect
the device from sudden impact and excessive mechanical force. Do not use the product in explosive environment or close to flammable
materials. Store the device in a dry cool place. Only use accessories and spare parts for this device that comply with the technical
specifications. Never attempt to operate a damaged device or a device with damaged electrical parts! If a part of the device or battery is
swallowed, seek medical attention immediately.
Battery safety instructions
Always purchase the correct size and grade of battery most suitable for the intended use. Always replace the whole set of batteries at one
time; taking care not to mix old and new ones or batteries of different types. Clean the battery contacts and also those of the device prior
to battery installation. Make sure the batteries are installed correctly with regard to polarity (+ and –). Remove batteries from equipment
that is not to be used for an extended period of time. Remove used batteries promptly. Never short-circuit batteries as this may lead to high
temperatures, leakage, or explosion. Never heat batteries in order to revive them. Do not disassemble batteries. Remember to switch off
devices after use. Keep batteries out of the reach of children, to avoid the risk of ingestion, suffocation, or poisoning. Utilize used batteries
as prescribed by your country's laws.
Levenhuk International Warranty
Levenhuk products, except for their accessories, carry a 5-year warranty against defects in materials and workmanship. All Levenhuk
accessories are warranted to be free of defects in materials and workmanship for six months from the purchase date. The warranty entitles
you to the free repair or replacement of the Levenhuk product in any country where a Levenhuk office is located if all the warranty conditions
are met.
For further details, please visit: levenhuk.com/warranty
If warranty problems arise, or if you need assistance in using your product, contact the local Levenhuk branch.
Settings
When the device is off, press (8) for 5 seconds to enter the settings. Press (7) to
switch between SET 1 (beep/voice switch) and SET 2 (calibration). Press (8) to
change the current setting.
0.05–60m
±2 mm
m/ft/in/ft+in
class II, 630–670nm, <1mW
5 m
laser tape – 2 min; backlight – 15s; laser – 30s
0... +40°C (operating), –10... +60°C (storage) /
+32...+104°F (operating), +14...+140 °F (storage)
390mA·h 3.7V rechargeable lithium battery
4