Publicidad
Idiomas disponibles
Idiomas disponibles
EN (Translation of the original language)
12
INSTALLATION
ATTENTION
PRELIMINARY
- Verify that all components are present. Request any missing parts from the manufacturer.
- Check that the pump has not suffered any damage during transport or storage.
INSPECTION
- Carefully clean the suction and delivery inlets and outlets, removing any dust or other packag-
ing material that may be present.
- Check that the electrical data corresponds to those indicated on the data plate.
- Always install in an illuminated area.
- Install the pump at a height of min. 80 cm.
12.1
POSITIONING, CONFIGURATIONS
AND ACCESSORIES
NOTE
ATTENTION
NOTE
ATTENTION
ATTENTION
This manual belongs to PIUSI S.p.A. Whole or partial reproduction of this manual is forbidden.
The pump must never be operated before the delivery and suction lines
have been connected.
In the case of installation in the open air, proceed to protect the pump by
providing a protection roof.
The pump can be installed in any position (pump axis vertical or horizontal)
The pump must be secured in a stable way using the holes on the bed of the
motor and vibration damping devices.
THE MOTORS ARE NOT OF THE ANTI-EXPLOSIVE-TYPE. DO NOT in-
stall them where inflammable vapours could be present.
The broad range of pump accessories make it suitable for many different uses, installa-
tions and applications. The supporting base can be positioned in different ways.
It is the responsibility of the installer to provide the necessary line ac-
cessories to ensure the correct and safe operation of the pump. The ac-
cessories that are not suitable to be used with the previously indicated
material could damage the pump and/or cause injury to persons, as well
as causing pollution.
To maximise performance and prevent damage that could affect pump
operation, always demand original accessories.
DIAPHRAGM PUMP AC
9
9 /48
/124
Publicidad
