Energy SLT966 Instrucciones De Uso Y De Montaje página 15

for two seconds. When Leds light on, press
buttons:
(within 5 seconds). Leds flashing 3 times in-
dicate
the procedure is completed.
WARNING! This operation deletes perma-
nently the preset codes.
Learniing the new transmiissiion code:
Once the transmission code is changed in the
radio control unit, the electronic central unit
of the cooker hood must be made to set the
new code in the fol- lowing way:
Press the main power-off button of the hood
(fig. 11) and then restore power to the elec-
tronic control unit. Within the next 15 secon-
ds, press the Liight Button
the central unit with the code.
Reset of the Factory confiiguratiion:
To restore the Factory configuration, follow
the pro- cedure described below: press si-
multaneously buttons:
for 2 seconds. When Leds light on, press but-
tons:
(within 5 seconds). Leds flashing 6 times in-
dicate the procedure is completed.
WARNING! This operation deletes perma-
nently the preset codes.
Emergency button:
In the event that the radio control does not
work, use the emergency button to switch
the appliance off. After any necessary repairs
have been performed, reset the emergency
button.
to synchronise
The products are endowed with an electronic
device which allows the automatic switching
off after 4 hours working from the last ope-
ration.
15
WARNIING
The battery should be replaced every year
to guarantee the optimal range of the
transmitter.
To replace the exhausted battery, take the
plastic lid off, remove the battery and re-
place it with a new one, observing the cor-
rect battery polarities.
Used batteries should be discarded in spe-
cial collection bins.
The below product:
RC001 Radiio Controll
complies with the specifications set out in
the R&TTE Directive 99/5/EC.
WARNING
Any adjustments or modifications which
have not been expressly approved by the
holder of the legal conformity certificate
may invalidate the user's rights relating to
the operation of the device.
Rev. 0 26/08/14