Amica VM 8200 Leste Aqua Manual De Instrucciones página 9

Instructions:
• Do not wash the brush. If hair is caught in the brush, remove
it with scissors or a knife.
Clean the dust filter at least once a month, depending on frequen-
cy of use.
• Turn the dust bin and remove it.
• Twist the strainer and remove it.
• Remove the foam filter and bracket.
• Separate the foam filter from the fleece filter by sliding them
apart.
• Rinse and dry thoroughly. Assemble when dry.
Clean a filter behind the motor every about 6 months, depending
on the frequency of use.
• Turn the filter cover and remove it.
• Remove the filter located behind the motor
• Shake off the dust.
• Every about 6 months, replace the filter or rinse and dry it
thoroughly.
• Put the filter and cover back in and turn to the "locked" po-
sition.
How to work with the mopping attachment?
Note!
• Fill the mopping attachment with clean water;
• Moisten the mopping pad and place it on the mopping at-
tachment;
• Place the vacuum cleaner brush in the mopping attachment;
• Start vacuuming by turning on the vacuum cleaner with the
power button, set the mode according to your preference;
• When the mopping pad starts to dry, pump water using the
footswitch on the mopping attachment;
• When you finish vacuuming and mopping, turn off the vacu-
um cleaner, then remove the mopping attachment with the
pad, wash or rinse the pad and pour out the water from the
mopping attachment.
• NOTE 1: Before working with the mopping attachment, you
should soak and thoroughly wring the mopping pad for better
result. When the pad is not wet enough, pump water using
the footswitch on the mopping attachment.
• NOTE 2: Only add clean water to the mopping attachment, no
detergents can be added.
Description of the problem
1. The vacuum cleaner does
not clean well..
2. The vacuum cleaner has
turned off or is not working.
3. The floor brush motor
turns off.
9
Procedure:
1. Empty the dust container.
2. Remove excess dust from
the filters.
3. Wash the filters.
4. Ensure there is no blockage.
1. Charge the vacuum cleaner
(check that the mains socket
is working and that the switch
is on).
2. Roller brush motor overhe-
ated due to heavy load. This
may be due to prolonged use
on a long­pile carpet or soft
rug. Allow the vacuum cleaner
to cool down for a minimum
of an hour before using it
again.
1. The floor brush is blocked
— refer to the "Electric brush
cleaning and maintenance"
section of this manual.
2. Brush motor overheat pro-
tection has tripped. Turn off
the vacuum cleaner, remove
the brush and let it cool down
for an hour, then try again.
EN