Publicidad
Idiomas disponibles
Idiomas disponibles
SAVE THESE INSTRUCTIONS
STANDARDS:
This edger attachment
is Lis!ed by Underwriter's
Laboratories,
Inc., in accordance with UL Standard 1602, Gasoline-Engine-Powered,
Rigid-
Cutting-Member
Edgers and Edger Trimmers," only when used with the following
models:
25cc Powerhead (with trimmer attachment) ...................
358.795501
25cc Powerhead (with trimmer attachment) ...................
358.745501
CARTON CONTENTS
Check carton contents against the fol-
lowing list.
Model 358.792401
Edger Attachment
Handlebar (with Clamp and Knob)
Clamp Base (with Spacer Tabs)
Clamp Screws (4)
Attachment Hanger
Hex Wrench
Examine parts for damage. Do not
use damaged parts.
NOTE: If you need assistance or find
parts missing or damaged, call
1-800-235-5878.
ASSEMBLY
_
WARNING:
If received
as-
sembled,
repeat all steps to ensure
your unit is properly assembled and all
fasteners are secure.
* A hex wrench (provided) is required
for assembly.
HANDLEBAR ASSEMBLY
_1_ DANGER:
RISK OF CUT. To
avoid serious injury, the barrier portion
of the handlebar must be installed as
shown on the upper tube of the pow-
erhead to provide a barrier between
operator and the spinning blade. At-
tach tube clamp above arrow on safe-
ty warning decal on the upper tube
dPowerhead end of unit). Ensure han-
lebar is positioned on handlebar
clamp between the arrows on the han-
dlebar decal.
NOTE:
The tube clamp base has four
spacer tabs attached.
These tabs are
provided to adapt this attachment for
use with powerheads
that have a 1"
diameter upper tube (the tube clamp
will not tighten down securely on the
1" diameter upper tube without using
these spacer tabs). The tabs must be
broken off completely before use and
placed over the screw holes on the
clamp base. These tabs are not need-
ed for powerheads
with a 7/8" upper
tube.
HANDLEBAR CLAMP BASE
Spacer T_4_lb,. _ _
Spacer Tabs
-_
se
upper tube
_I
1. Place the tube clamp over the up-
per tube above the arrow on the
safety decal.
2. Position the clamp base under the
upper tube and align the tube
clamp and clamp base screw holes
(use spacer tabs between tube
clamp and clamp base if necessary
to secure clamp, i.e. for 1" diameter
upper tube).
Handlebar
POWERHEAD
END
Handlebar
Clamp
between arrows on
handlebar decal
Knob
Screws
Arrow on
Safety Decal
ATTACHMENT
END
3. Insert the four screws into the
screw holes.
4. Secure tube clamp by tightening
screws with the hex wrench.
6
Publicidad
