Loose Parts In Carton; Tools Needed For Assembly - Sears Craftsman professional 247.889360 Manual Del Operador

Tabla de contenido

Publicidad

IMPORTANT:This unit is shipped with oil in the engine.
After assembly, see OPERATION section of this
manual for fuel and engine oil details.
NOTE:
Reference to right and left hand side of the
mower is observed from the operating position.
This pedestrian controlled wide area mower has been
completely assembled at the factory.
LOOSE PARTS IN CARTON
The following items are packaged in a bag:
Operator's Manual and Engine Manual
TOOLS NEEDED FOR ASSEMBLY
A tire Gauge
REMOVING THEUNITFROM THECRATE
1.
Cut straps securing unit to pallet.
2.
Remove any protective packaging and plastic tie
straps.
REMOVING THECHUTE STRAP
1.
Locate the chute strap which secures the discharge
chute in a vertical position.
2.
Pull chute back towards the engine. While holding
the chute with one hand, cut the strap with the other
hand.
FINALADJUSTMENTS
Tire Pressure
The recommended operating rear tire pressure is 10-
12 psi. The caster wheels are semi-pneumatic
and do
not require air pressure. Check the tire pressure
periodically and maintain equal pressure in both rear
tires at all times.
IMPORTANT:
Refer to the tire sidewall for exact tire
I
manufacturer;s recommended or maximum psi. Do not
overinflate. Uneven tire pressure could cause the
cutt ng deck to mow uneven y.
11

Publicidad

Tabla de contenido
loading

Tabla de contenido