Infiniton CMPT-TSH6B40 Manual Del Usuario página 22

Installation
English
Check the safety status of the appliance:
Lower decorative chimney
Attach the exhaust pipe to the hood body, join the chimney and the hood
body with 2 screws, join the chimney support and the chimney fixing with
2 screws 12.
Fitting the hood body
Place the extractor hood body on the bracket 20.
Level the extractor hood body.
Remove the filter from inside the extractor hood body, fix the screws 10 to
the wall sockets 11 at the points (3).
CONNECTIONS
EXTRACTOR DEVICE IN THE EXTRACTION VERSION.
When installing the extraction version, connect the hood to the air dis-
charge pipe using a 150 mm or 120 mm diameter rigid or flexible pipe,
the choice of which is at the discretion of the installer.
To install a 120 mm diameter air discharge connection, insert the reduc-
tion clamp 3 into the air outlet.
Secure pipe 4 in position using suitable pipe clamps (not supplied).
Remove the charcoal filters.
Upper decorative chimney
Insert the upper decorative chimney 2.2 into the lower decorative chimney 2.1 and drag it towards the
horizontal line B.
Connect the upper decorative chimney 2.2 and the chimney fixing bracket 21 with 2 screws 12.
22
infiniton.es