Publicidad
Idiomas disponibles
Idiomas disponibles
_
ARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR
ADJUSTMENTS:
1_ Depress
clutch/brake
pedal fully and set parking
brake.
3,
Place attachment
clutch
in "DISENGAGED"
position,
4, Turn ignition
key to "STOP" and remove
key,
5,
Make sure the blades
and all moving
parts have completely
stopped,
6,
Disconnect
spark plug wire from spark plug and place wire where it cannot come
in contact with plug,
TO
REMOVE
MOWER
1_ Place
attachment
clutch
in "DISEN-
GAGED"
position.
2.
Lower
attachment
lift lever to its lowest
position.
3.
Disengage
belt tension
rod (K) from lock
bracket
(L).
_,
CAUTION:
Belt
tension
rod is spring
loaded.
Have a tight grip on rod and release
slowly.
4.
Remove
mower belt from electric clutch
pulley
(M).
5.
Disconnect
front link (E) from mower
-
remove
retainer
spring and washer.
6.
Go to either side of mower and disconnect
mower
suspension
arm (A) from chas-
sis and rear lift link (C) from rear mower
bracket (D) * remove retainer springs and
washers.
7.
Go to other side of mower and disconnect
the suspension
arm and rear lift link.
CAUTION:
After rear lift links are discon-
nected, the attachment
lift lever will be spring
loaded° Have a tight grip on lift lever when
changing
position
of the lever.
B.
From right
side
of mower,
disconnect
anti-sway
bar (S) from right rear mower
bracket
(D) - remove retainer spring and
washer
and pull mower toward you until
the bar falls from the hole in bracket.
9, "t_,_rn tractor steering
wheel to the left as
far as it will go.
10oSlide mower out from under right side of
tractor.
TO INSTALL
MOWER
Follow
procedure
described
in "INSTALL
MOWER AND DRIVE BELT" in the Assembly
section
of this manual.
26
Publicidad
