Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
BATTERY
_,WARNING:
Do not short battery terminals
by allowing
a wrench
or any other object to
contact
both terminals
at the same time.
Before
connecting
battery,
remove
metal
bracelets,
wristwatch
bands,
rings,
etco
Positive
terminal must be connected
first to
prevent sparking from accidental
grounding.
1. Lift hood to raised position.
2o Disconnect
BLACKbattery
cable (A) then
RED battery cable and carefully
remove
battery from tractor.
3_ install new battery with terminals
in same
position
as old battery.
4.
First connect
RED battery
cable
(B) to
positive
(+) battery terminal with hex bolt
and keps nut as shown.Tighten
securely.
Slide terminal
cover (C) over terminal,
5, ConnectBLACKgroundingcabteto
neg-
ative (-) battery terminal
with remaining
hex bolt and keps nut. Tighten securely_
6.
Close hood.
_ _ Negative
(Black)
Cable
Positive
(Red)
Cable
TO REPLACE
HEADLIGHT
BULB
1o Raise hood.
2.
Remove
bulb holder from the hole inthe
backside
of the grill.
3.
Replace
bulb in holder
and install bulb
holder securely
back into the hole in the
backside
of the grill.
4o Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged
wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
, Check wiring.
TO REPLACE
FUSE
Replace with 30 amp automotive-type
plug-
in fuse.
The fuse holder is located
behind
the dash.
TO REMOVE
HOOD AND GRILL
ASSEMBLY
1. Raise hood.
2.
Unsnap headlight
wire connector.
3o Stand in front of tractor.
Grasp
hood at
sides,
tilt toward
engine
and lift off of
tractor.
4.
Whenreplacinghood,
besuretoreconnect
the headlight
wire connector.
Hood
Headlight Wire
Connector
TRANSMISSION
REMOVAL/REPLACE-
MENT
Should your transmission
require removal
for service
or replacement,
it should
be
purged after reinstallation
and before
op-
erating the tractor.
See "PURGE
TRANS-
MISSION"
in the Operation
section
of this
manual.
ENGINE
TO
ADJUST
THROTTLE
CONTROL
CABLE
The
throttle
control
has
been
preset
at
the factory
and adjustment
should
not be
necessary
Check
adjustment
as described
below before loosening
cable. If adjustment
is necessary,
see engine manual.
TO ADJUST
CHOKE
CONTROL
The
choke
control
has
been
preset
at
the factory
and adjustment
should
not be
necessary.
If adjustment
is necessary,
see
engine manual.
TO ADJUST
CARBURETOR
Your carburetor has been preset atthe factory
and adjustment
should
not be necessary.
However, minor adjustment
may be required
to compensate
for differences
in fuel, tem-
perature,
altitude or Ioado If the engine does
need adjustment,
see engine
manual.
3O
Publicidad
