Craftsman 358.799701 Manual De Instrucciones página 6

KNOW YOUR GUTTER ATTACHMENT
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare illustrations to your unit to familiarize yourself with the location of
the various controls and adjustments. Save this manual for future reference.
_ Collar for Adapter for Adapter for
N ozz,_/ LJ Gas Units _ Gas Units _ Electric UnitSwith Tube
Pivot Tube
\ _E._nsion Tube _ Decal Release Button
Elbow with Spacer Ring _
STARTING INSTRUCTIONS
,_ WARNING: You MUST make sure
the tubes are secure before using the
unit. Do not use the unit without all of
the tubes properly attached to avoid fly-
ing debris and/or impeller contact which
can cause serious injury. Always wear
eye protection to prevent rocks or debris
from being blown or ricocheting into the
eyes and face which can result in blind-
ness or serious injury.
_l_ WARNING: Hold the unit as illus-
trated when starting (for gas units
only). Do not set unit on any surface
except a clean, hard area when start-
ing and/or using the unit. Debris such
as gravel, sand, dust, grass, etc could
be picked up by the air intake and
thrown out through the discharge
opening, damaging the unit or proper-
ty, or causing serious injury to bystand-
ers or the operator.
NOTE: When starting unit, lean the top of
gutter attachment against a wall, tree, etc.,
for support.
STARTING _,_
POSITION
(for gas
units only)
• Support the gutter attachment with
one hand as soon as the engine or
motor starts.
SUPPORT _S'
THE TUBES
>
OPERATING TIPS
• Wear eye protection to guard against
eye injury.
• To reduce the risk of hearing loss as-
sociated with sound level(s), hearing
protection is required.
• To reduce the risk of injury associated
with contacting rotating parts, stop the
engine/disconnect from the power
source and wait until impeller has
completely stopped turning before
installing or removing attachments.
• Stand 3 to 4 feet away from building.
• Rotate the pivot tube to position the
nozzle right or left.
• Follow the STARTING INSTRUCTIONS
in your operator's manual.
-6-