Briggs & Stratton GENERAC 2400PSI Manual Del Propietário página 10

2. Point nozzle down towards a firm surface and press
trigger to test spray pattern (Figure 10).
Figure 10 — Testing the Spray Pattern
3. Twisting nozzle adjusts spray pattern from a narrow
pattern to a fan pattern (Figure 11).
Figure 11 — Adjusting the Nozzle for Spray Pattern
Clockwise = Narrow Spray
Pattern
Usage Tips
• For most effective cleaning, keep spray nozzle from 8 to
24 inches away from cleaning surface.
• If you get spray nozzle too close, especially using high
pressure mode, you may damage surface being cleaned.
• DO NOT get closer than 6 inches when cleaning tires.
Applying Detergent with the
Adjustable Nozzle
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
CAUTION
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
Generac Portable Products 2400 PSI Pressure Washer
Counterclockwise = Fan
Spray Pattern
To apply detergent, follow these steps:
1. Review use of adjustable nozzles.
2. Prepare detergent solution as required by job.
3. Hang the detergent solution on the hook of the
wireform attached to the handle, as shown in
Figure 15.
Figure 15 — Insert Filter into Container
4. Place filter end of chemical injection hose into
detergent container.
CAUTION
Keep the chemical injection tube from coming in contact
with the hot muffler.
• When inserting the filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently contacting
the hot muffler.
5. Slide adjustable nozzle forward to low pressure mode.
Detergent cannot be applied with nozzle in high
pressure position.
6. Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump. Start engine.
7. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
8. Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapply as needed to prevent
surface from drying. DO NOT allow detergent to dry
on (prevents streaking).
IMPORTANT: You must flush the chemical injection
system after each use by placing the filter into a bucket of
clean water, then run the pressure washer in low pressure
for 1-2 minutes.
10