Assembly; Carton Contents - Briggs & Stratton GENERAC 2400PSI Manual Del Propietário

ASSEMBLY

IMPORTANT: Read entire owner's manual before you
attempt to assemble or operate your new pressure washer.
Remove Pressure Washer from
Carton
• Remove parts box included with pressure washer.
• Slice two corners at end of carton from top to bottom
so panel can be folded down flat, then remove all packing
material.
• Roll pressure washer out of carton.

Carton Contents

Items in the carton include:
• Main Unit
• Parts Box (which includes the following):
• Wireform
• Goggles
• Handle Assembly
• Handle Fastening Hardware
• High Pressure Hose
• Owner's Manual
• Engine Manual
• Owner's Registration Card
• Spray Gun
• Nozzle Extension
• Oil Bottle
• Maintenance Kit
If any of the above parts are missing or damaged, call the
pressure washer helpline at 1–800–270–1408.
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-270-1408.
To prepare your pressure washer for operation, you
will need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle and wire form.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
Generac Portable Products 2400 PSI Pressure Washer
5.
6.
7.
Attach Handle and Wire Form
1.
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2.
3.
4.
6
Connect high pressure hose to spray gun and pump.
Connect water supply to pump.
Attach nozzle extension to spray gun.
Place handle onto handle supports already connected
to main unit. Make sure holes in handle align with
holes on handle supports (Figure 1).
Figure 1 — Attach Handle to Base
Align Holes
Insert carriage bolt through left hole (from the rear of
the unit) and attach a plastic knob. Tighten by hand
(Figure 2).
Figure 2 — Secure Handle
Insert carriage hook through right hole (from the rear
of the unit). Pull recoil handle out slowly. Place recoil
string through hook and attach plastic knob. Tighten by
hand (Figure 2).
Insert wire form with longer arm positioned on left.
From rear of unit, the hook should resemble a "J"
(Figure 3).
Figure 3 — Attach Wire Form to Handle
Handle
Handle
Supports