Important Safety Instructions & Guidelines
Risk from
Flying Objects
Risk to Breathing
L
Risk of
Electrical Shock
Risk of
Explosion or Fire
Risk of Bursting
Always wear ANSI Z87,1 approved safety glasses with side shields when the air
compressor is in use. Turn off the air compressor and drain the air tank before
performing any type of maintenance or disassembly of the hoses or fittings. Never point
any nozzle or sprayer toward any part of the body or at other peopfe or animals.
Avoid using the air compressor in confined areas. Always have adequate space
(12 inches) on all sides of the air compressor. Also keep children, pets, and others out of
the area of operation. This air compressor does not provide breathable air for anyone or
any auxiliary breathing device. Spraying material will always need to be in another area
away from the air compressor to not allow intake air to damage the air compressor filter.
Never utilize the air compressor in the rain or wet conditions. Any electrical issues or
repairs should be performed by authorized personnel such as an electrician and should
comply with all national and local electrical codes. The air compressor should also have
the proper three prong grounding plug, correct voltage, and adequate fuse protection.
Never operate the compressor near combustible materials, gasoline or solvent vapors.
If spraying flammable materials, locate the air compressor at least 20 feet away from the
spray area. Never operate the air compressor indoors or in a confined area.
Drain the air compressor tank daily or after each use. if the tank develops a leak, replace
the air compressor. Never use the air compressor after a leak has been found or try to
j,, m ca ionsot
ter d the
co ro oto s
which control the tank pressure or any other function.
Spe iflcations
Pump .............................
Oil-free direct drive
Motor Induction .....................
1.5 HP
Bore ..............................
2.48"
Stroke ............................
0.86"
Voltage Single Phase ................
120 VAC
Minimum Circuit Requirement ..........
15 Amps
Air Tank Capacity ....................
7 Gallons
Cut-in Pressure .....................
105 PSI
Cut-out Pressure ....................
135 PSI
SCFM @ 90 PSI ....................
3.0
SCFM @ 40 PSI ....................
5.0