Publicidad
Idiomas disponibles
Idiomas disponibles
Glossary
CFM:
Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of measure
for air delivery.
PSlG:
Pounds per square inch gauge; a unit of measure
for pressure.
ASME: American Society of Mechanical Engineers.
California Code: Unit may comply with California Code
462 (!) (2)/(M) (2).
Cut-In Pressure: The air compressor will automatically
start to refill the tank when the pressure drops
below the prescribed minimum.
Cut-Out Pressure: The point at which the motor stops
when the tank has reached maximum air
pressure.
Code Certification:
Products that bear one or more of
the following marks: UL, ETL or CSA, have
been evaluated by OSHA-certified independent
safety laboratories and meet the applicable
Underwriters Laboratories Standards for Safety.
Duty Cycle
This is a 50% duty cycle air compressor. Do not operate the air compressor more than 30 minutes of one hour.
Doing so could damage the air compressor,
Parts & Features
See figures below for reference.
Drain Valve: Used to drain condensation from the air
tank, Located at bottom of tank (see parts diagram).
MotorThermat Overload: The motor has a manual
thermal overload protector, if the motor overheats,
this protector will shut off the motor. To restart the motor
turn off the pressure switch and then turn the switch back
to the "On" position.
Quick Connect: Offers a quick release feature for
attaching and removing the air hose.
Pressure Switch: This controls the power to the motor
and also the cut-in/cut-out pressure settings. This switch
serves as the Auto-On/Off positions for the unit,
Air Intake Filter: Provides clean air to the pump and
must always be kept free of debris. Check on a daily basis
or before each use.
Air Compressor Pump: Oil free direct driven pump that
compresses air which is distributed to the tank (not shown).
Check Valve: When the pump is not in operation the
valve closes to retain air pressure inside the tank.
An internal component.
Regulator Pressure Gauge
Quick Connect
//
"Tank
Safety Valve
I
Regulator
Pressure Relief Valve: The pressure relief valve,
located on the side of the pressure switch, is designed
to automatically release compressed air when the air
compressor reaches cut-out pressure. The released air
should only escape momentarily and the valve should
then close.
Tank Safety Valve: Used to allow excess tank pressure
to escape into the atmosphere. This valve should only
open when the tank pressure is above the maximum rated
pressure,
Regulator
Pressure
Gauge:
Indicates
the outgoing air
pressure
to the tool and is controlled
by the regulator.
Tank Pressure Gauge: Indicates the reserve air pressure
in the tank.
Regulator: The air pressure coming from the air tank is
controlled by the regulator. To increase the pressure turn
the knob clockwise and to decrease the pressure turn the
knob counterclockwise.
\\\
_
\
\
J
Pressure Relief Valve
/
i
'\
j j_.
Filter
Check Valve
Publicidad
