PARK TOOL CO.
PARK TOOL CO.
The DC-2 is a precision measuring instrument built with
stainless steel parts and a rugged alloy body.
• Measures to 150 mm/6 in
• Measures external, internal, depth and stepped
dimensions
• Resolution: 0.01 mm/0.0005 in
• Accuracy: +/-0.02 mm/0.001 in (<100 mm)
+/-0.03 mm/0.001 in (100-150 mm)
• Repeatability: +/-0.01mm/0.0005 in
OPERATION:
1. Loosen locking screw to allow movement of slider.
2. Press and release OFF/ON button.
3. Press mm/in button to switch between
measurement units.
4. Close measuring jaws using light measuring pressure
and press ZERO button to reset display to 0.00.
1
3
05/22
DC-2
5115 Hadley Ave. N., St. Paul, MN 55128 (USA) www.parktool.com
5115 Hadley Ave. N, St. Paul, MN 55128 (USA) parktool.com
DC-2 Digital Caliper
Trouble
Five digits flash simultaneously
Display doesn't change when
slider is moved
No reading on display
Instructions
5. Measure part as shown in Figures 1 through 4.
• Figure 1: Measurement of external dimensions
• Figure 2: Measurement of internal dimensions
• Figure 3: Measurement of depth
• Figure 4: Measurement of stepped dimension
MAINTENANCE:
1. Handle with care. Avoid exposure to dirt, moisture, and
extreme temperatures.
2. Keep DC-2 clean and dry for proper performance.
Clean with a dry, soft, cotton cloth. Do not use water or
cleaning solutions.
3. To save battery power, turn off DC-2 when idle.
BATTERY REPLACEMENT:
Flashing digits in the display indicates the battery needs
replacement. Remove the battery cover using the included
screwdriver. Replace battery (LR44 button cell) with
positive side facing out.
2
4
Action
Replace battery
Remove battery for 30 seconds,
then reinstall
1. Check for proper battery connection
2. Replace battery
PARK TOOL® and the color BLUE are registered trademarks of Park Tool Co.
© 2022 Park Tool Co.