Kenmore 970 Guia Del Propietario página 8

Theiceandwater d ispenser onthefreezer door c onve-
niently d ispenses chilled water a ndicecubes.To operate
thedispenser, slide theknob totheselection o fyour c hoice
andpress a glass against thedispensing arm,asshown,
Besure tohold theglass asfarupaspossible tocatch all
cube& Tostop dispensing, pull g lass away f romdispens-
ingarm.Release dispensing armbefore theglass isfull,
butdonotremove t heglass until t heicehascompletely
dispensed.
A small heated area beneath the dispenser floor catches
and evaporates small spills, This drip tray is removable and
dishwasher safe_ Do not pour water or excess cubes into
this area because there is no drain.
LIGHT
The dispenser has a light which can be turned on and off by
sliding the knob to the desired position, The lightalso turns
on automatically when ice and/or water is dispensed,. Re-
place lightbulb with an appliance bulb of the same wattage.
Dispenser Selector
Slide Knob
Touch Pad
HOW THE WATER DISPENSER WORKS
The water tank is located behind the drawers inthe refrig-
erator compartment. As the water is dispensed, the tank is
automatically refilled. For properoperation of the dispenser,
the supply water pressure must fall between 30 psi and 120
psi
After the refrigeratoris installedand the plumbing connec-
tions are complete, the water tank should be filled by
drawing one glass of water. This will take about 1-1/2
minutes° Then, draw and discard7 more glasses to be sure
that the tank and plumbing connections are rinsedof any
impurities_ T he water delivery system has a built in shut off
device that willstop the water flow after 3 minutes of
continuous use. Simply release the actuator button to
resset the dispensing mechanism
7bensure fresh-tasting water, plan to use thedispenser
every day_ If the water dispenser has not been used for a
week or more, draw and discard 7-8 glasses to freshen the
tank supply
HowTHE iCE DISPENSER WORKS
The ice maker and ice storage bin ate located in the top reft
corner of the freezer compartment. After the refrigerator is
installed properly and has cooled for several hours, the ice
maker can begin making ice, To begin ice production, lower
the wire signal arm to the "down" or ON position° As cubes
are made, they are stored in the storage bin. Although it
may take 1 or 2 days to fit! the bin, the dispenser may be
used after the first batch of ice is made. The ice maker
turns off automaticafly when the ice storage bin is full
Because of new plumbing connections, the first production
of ice cubes may be discolored or have an odd flavor
These should be discarded until the cubes made are free
of discoloration and taste. _ Remember, water
quality determines your ice quality it [s best to connect the
ice maker to water that is not softened.. Contaminants from
a malfunctioning softener can damage the ice maker. If ice
maker is connected to soft water; ensure the softener is
maintained and working properly.
Press glass against dispensing arm
Touch Pad
To stop the ice maker, lift the wire signal arm until it clicks
and rocksin the "up" or OFF position.
t .....