Kenmore 970 Guia Del Propietario página 5

This Owner's Guide provides specific operating instructions
for your model. Use the refrigerator only as instructed in
this Owner's Guide. Before starting the refrigerator,
follow these important first steps.
LOCATION
• Choose a place that is near a grounded electrical
outleL Do Not use an extension cord or an adapter
plug.
• If possible, place the refrigerator out of direct sunlight
and away from the range, dishwasher or other heat
sources.
The refrigerator must be installed on a floor that is
level and strong enough to support a fully loaded
refrigerator.
• Consider water supply availability for models equipped
with an automatic ice maker
INSTALLATION
• Do not install the refrigerator where temperature wilt
drop below 60°F (15°C) or rise above 110°F (43°C).
The compressor will not be able to maintain proper
temperatures.
• In a recessed installation, allow an extra 1/2 inch
(10-15 mm) on each side, for ease of installation.
To permit proper door swing, if the hinge side of the unit
wilt be placed against a wall, allow a 1- 3/4 inch
(44 mm) space between the wall and the refrigerator,
DOOR OPENING
The doors should open to allow easy access to a counter
when removing food.
• Do not position the refrigerator so you have to walk
around the refrigerator doors,
LEVELING
Refrigerator must be leveled with ait bottom corners
resting firmly on a solid floor. Adjust front rollers to level
cabinet both front-to-rear and side-to-side Keep
cabinet as low as possible for stability, Never adjust
cabinet rollers so front is lower than rear,
To adjust front rollers: Open refrigerator and freezer
doors Remove toe grille by pulling it straight ouL
Adjust rollers by turning each rolter adjusting bott with
an adjustable wrench, a socket wrench, or a nutdriver
until the refrigerator is level and stable. Rear rollers are
not adjustable.
Check both doors to ensure the seals touch the
cabinet evenly on all four corners
° Iffreezerdoor.!shigherthanrefrgerat£rd0or,+rais e ..
right corner and/or lower left corner until doors align
across top of cabinet°
• if reldgerator door is h}gher than freezer door, raise Jeft
corner and/or lower right corner until doors align across
top of cabinet.
ROLLER AD3UST_NG
BOLT
Adjusting Front Rollers
Replacing Toe Grill
• To replace toe grille: Line up tabs with holes, and
push grill straight on.
CLEANING
• Wash the inside, all removable parts, and the outside
with mild detergent and warm waten Wipe dry, Do Not
use harsh cleaners on these surfaces°
• Do not use razor blades or other sharp instruments that
can scratch appliance surface, when removing adhe-
sive labels, Any glue left from tape or energy label can
be removed with a mixture ofwarm water and mild
detergent, or touch residue with sticky side of tape
already removed,
• Do not remove the Serial Plate,