OPERATION ______________________________
Preparation
Caution
Switch off the appliance and disconnect it
█
from supply before changing accessories or
approaching parts that move in use.
Do not remove the blade unit by lifting it from
█
the blades.
The blade unit is very sharp! Handle the blade
█
unit with utmost care, especially during clean-
ing, in order to avoid injuries.
Note
Make sure that the notches on the bottom of
█
the glass jug fit those in the motor housing.
Blending
Notes
Add water to ensure the jug blender functions
█
smoothly.
Mix 3 units of hard food and 2 units of water
█
in order to have a smooth jug blender experi-
ence. (i.e: 60 gr hard food 40 ml water)
Caution
Do not put or blend hot food or liquids in the
█
glass jug. If you process soup, make sure that
the liquid temperature does not exceed 40°C.
To process crushed ice, we suggest you to start
█
with three quarters of ice in the jug and add 15
ml of cold potable water.
Don´t try to crush ice without adding water to
█
the jug.
Never let the jug blender operate while empty
█
(without food).
Never let the jug blender operate without the
█
glass jug on the motor housing.
Never move or turn the glass jug after it is prop-
█
erly seated in the place.
Notes
To operate the blender at low speed, turn the
█
H
control dial
to "1".
If you want to blend with a higher speed, turn
█
the control dial
H
(5-6).
For short pulses of blending with a high speed,
█
turn the control dial
lease the control dial
and return to "0" automatically.
If ingredients are to be added during the blend-
█
ing process, then add them through the open-
ing in the lid
. To do this, take out the cap/
B
measuring cup
.
A
Caution
Never run the blender for longer than 1 minute,
█
otherwise it would overheat.
After running the appliance for 1 minute, let it
█
cool down before using it again.
Be sure the motor is switched off and has com-
█
pletely stopped before removing the glass jug
from the motor housing
D
Do not place any utensil (scraper, fork, etc.) in
█
the glass jug while blender is operating.
to the desired speed level
H
to "P". When you re-
H
, the blender will stop
.
G
ENGLISH
19