Oase PondoVac 5 Puesta En Marcha página 20

Fitting the inlet
Prerequisite: The tank is open. (→ Opening/closing the tank)
How to proceed:
 F
1. Insert the intake distributor into the opening.
– Guide the pins on the intake distributor through the notches of the opening.
2. Twist the intake distributor to lock it into place (bayonet closure).
– Ensure that the outlet of the intake distributor in the tank is angled downwards.
3. Fit the debris collection bag onto the intake distributor in the tank.
– Ensure that the elastic of the debris collection bag is seated in the groove of the intake dis-
tributor.
– Secure the debris collection bag with the Velcro tape.
Installation and connection
 G
WARNING
Risk of severe injuries or death by electric shock.
 Install the unit at a distance of at least 2 m from the water.
 Place the unit on horizontal, firm ground to prevent it from tipping over.
NOTE
The vacuum cleaner can be set up and operated in a position that is up to 0.3 m lower than the
water level. However, when the vacuum cleaner is switched off, the water will automatically flow
through the tank while the suction hose remains in the pond/pool. This will empty the pond or
pool.
Always take the suction hose out of the pool/pond when the vacuum cleaner is switched off.

Adjusting the transport brace
How to proceed:
 H
1. Undo the locking screw.
2. Move the transport brace into the desired position.
3. Hand-tighten the locking screw.
20