Oase PondoVac 5 Puesta En Marcha página 21

Connecting the hoses and nozzles
The following conditions must be met:
• Allow the dirty water to drain out into a drain or far enough away from the pond to ensure
that it cannot flow back into the pond.
• Completely unwind the power and extension cable.
– Ensure that the cables are not bundled together or coiled up.
How to proceed:
 I
1. Attach the discharge hose to the outlet and twist it clockwise (bayonet closure).
– If only coarse dirt particles >1 mm (e.g. leaves or hair) are to be removed, you can allow the
waste water to flow back into the pond / pool via the fine filter bag.
– Do not allow muddy water to flow back into the pond / pool.
2. Attach the suction hose to the inlet.
3. Fit extension tubes and the desired nozzle to the suction hose with handle.
– Universal nozzle: For removing pond sludge without vacuuming up the pond gravel.
– Algae nozzle: For separating and removing string algae.
– Brush nozzle: For removing stubborn dirt.
– Surface cleaning nozzle: For cleaning large, smooth surfaces.
– Wet suction nozzle: For removing dirty or residual water for operation as a wet vacuum
cleaner

The more tubes are used, the higher the tube frictional resistance. This leads to a reduction
of the suction capacity.
Operation
NOTE
The unit and seals are subjected to excessive strain if the vacuum cleaner is moved when the
tank is full.
Empty the tank before moving the vacuum cleaner.


Set up the vacuum cleaner on ground that is not much higher than the water level to avoid
impairing the suction capacity.
• Switch on the vacuum cleaner at the power switch.
• The suction power can be adjusted with the slide in the suction hose handle.
– To increase the suction: Move the slide forwards.
– To reduce the suction: Move the slide backwards.
• Clean the vacuum cleaner after each use.
– Recommendation: Vacuum up clean water before cleaning. This will wash out the dirt parti-
cles.
EN
21