Kenwood KHC29.E0WH Instrucciones página 15

5 Whilst supporting the beaker holder,
fit the attachment to the outlet by
aligning the spout over the corner of
the machine and then turn clockwise
to lock into position.
6 To fit the beaker, rotate the holder
away from the spout and then place
the beaker in the holder. Rotate
the beaker so that it is located
underneath the juice outlet.
7 Cut the food to fit the food tube.
8 Turn to Max speed, then place the
food into the feed tub. Push down
evenly with the pusher – never put
your fingers in the feed tube.
Important
If the juicer starts to vibrate, switch
off and empty the pulp from the
filter. (The juicer vibrates if the pulp
becomes unevenly distributed).
Some very hard foods may make
your attachment slow down or
stop. If this happens switch off and
unblock the filter.
Switch off and empty the pulp and
juice containers regularly during use.
Hints and Tips
Citrus Fruit - For best result use
the Citrus juicer which is available
separately.
Insert soft food slowly to get the
most juice.
Remove stones (plums, peaches,
cherries etc).
Remove tough skins (melons,
pineapples, cucumbers, etc).
Soft-skinned and other foods
just need washing (apples,
pears, carrots, spinach, grapes,
strawberries, celery etc).
Health recommendations
To retain the vitamins drink the juice
as soon as possible.
If you need to store the juice for a
few hours put it in the fridge and
add a few drops of lemon juice to
keep it fresh.
Do not drink more than three 230ml
(8 fl.oz.) glasses of juice a day
unless you're used to it.
Dilute juice for children with an
equal amount of water.
Juice from dark green (broccoli,
spinach etc.) or dark red (beetroot,
red cabbage etc.) vegetables is
extremely strong, so always dilute it.
Fruit juice is high in fructose (fruit
sugar), so people with diabetes
or low blood sugar should avoid
drinking too much.
To dismantle the Juicer
Reverse the assembly procedure.
To remove the pulp container from base
unit - press the release lever on the base
unit and rotate the pulp container anti-
clockwise. Then lift off.
Compact Chopper/Mill
21
a
Base
b
Blade unit
c
Sealing ring
d
Jar
Assemble the Mill as shown in
21
illustration
1 Put your ingredients into the jar.
2 Ensure the sealing ring is correctly
fitted on the blade unit. Leaking will
occur if the seal is not fitted correctly.
3 Turn the blade unit upside down.
Lower it into the jar, blades down.
4 Screw the base onto the jar until it is
finger-tight.
11