Publicidad
Idiomas disponibles
Idiomas disponibles
3
ON/OFF
1
MODE
TEMP
FAN
SLEEP FRESH
TURBO SELF CLEAN
LED FOLLOW ME
ON/OFF
MODE
TEMP
FAN
SLEEP FRESH
TURBO SELF CLEAN
LED FOLLOW ME
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Press the MODE button to select DRY mode.
2. Press the UP/DOWN buttons to set the
desired temperature. The temperature
can be set within a range of 17 C~ 30 C
in 1 C increments.
2
3. Press the ON/OFF button to start the air
conditioner.
SHORT
CUT
NOTE
In the Dehumidifying mode, you can not switch the
TIMER
ON
fan speed. It has already been automatically controlled.
TIMER
OFF
Press the TIMER ON button can set the auto-on
time of the unit. Press the TIMER OFF button
can set the auto-off time of the unit.
To set the Auto-on time.
1. Press the TIMER ON button. The remote
controller shows TIMER ON, the last Auto-on
setting time and the signal "H" will be shown on
the LCD display area. Now it is ready to reset
the Auto-on time to START the operation.
2. Push the TIMER ON button again to set desired
Auto-on time. Each time you press the button,
SHORT
CUT
the time increases by half an hour between 0
and 10 hours and by one hour between 10 and
TIMER
1
ON
24 hours.
3. After setting the TIMER ON ,there will be a one
2
TIMER
OFF
second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal "h" will disappear and the set temperature
will re-appear on the LCD display window.
122
Dehumidifying operation
O
Timer operation
O
O
Publicidad
