Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
= Electrical connection
- Do not use an extension
cord or double
adapter
• If the supply
cord is damaged,
it must be replaced
by a qualified
person
in order to avoid a hazard
• If the machine
will not be used for an extended
time, unplug it and shut off the water supply
• Connect
the machine
to a grounded
outlet in accordance
with current wiring regulations
- The appliance
must be positioned
so that the plug is easily accessible
CAUTION!
Concerning
the Power Cord
Most appliances recommend they be placed upon a dedicated circuit; that is, a single outlet circuit which powers only that
appfiance and has no additianat outlets or branch circuits. Check the specification page of this owner's manual to be
certain,
Do not overload wall cutlets. Overloaded wall outlets, loose or damaged wall outlets, extension cords, frayed power cords,
or damaged or cracked wlre insulation are dangerous. Any of these conditions could result in electric shock or fire.
Periodk',ally examine the cord of your appliance, and if its appearance indicates damage or detedoratJom unplug it,
discontinue use of the appliance, and have the cord repfaced with an exact replacement part by an authorized servicer
Protect the power cord from physical or mechanical abuse, such as being twisted, kinked, pinched, closed [na door, or
walked upon. Pay particular attention to plugs, wall outlets, and the point where the cord exits the appliance,
= Connecting
water supply hose
Cold
water
tap
-Water supply pressure must be between
45 and 145 PSI (30-1000 kPa),
Do not crossthread when connecting inlet hose to
the valve.
If the water supply pressure is more than 145 PSI,
a pressure reducing device should be installed
Two Sealing washers are supplied with the water
inlet hoses to prevent water leaks.
Check for leakage of washing machine connections
by turningthe tap completely on
Periodically check the condition of the hose and
replace the hose if necessary
Make sure that there is no kink in the hose and that
it is not crushed
Be sure that the two water input ports are connected
to the correct water fatJcets..The connector for hot
water is colored red
NOTE:
Washing
Machine
is to be connected
to lhe water
mains using new hos_.
Old hoses should
eel be used,
Repairs
to the washing
machine
mus! only be carried out by qualified
personnel,
Repairs
carried out by
inexperienced
persong may cilllse injury
or serious malhmctioning.
Contact your local service eentero
i)o net instal! your washing
machine
in a room where
temperatures
below freezing may occur°
Frozen hoses may burst antler pressure°
The r¢liabillty
of the elee|reaic
control
unit may be impaired
at lemperatures
below the freezing point,
If the applinnce
is delivered
in the winter months
and temperatures
are below fre_ing_
store
|he washing
machine
at room temperature
for a few hours
hehwe putting it into operatiom
7
Publicidad
