Tools Required - Craftsman professional 171.61181 Manual Del Propietário

ASSEMBLING THE ROUTER TABLE
TABLE LEG iNSERTS (FIG. 1)
The router table includes two table leg inserts:
• Router bit storage panel (3) holds both 1/4 in.
and 1/2 in. shank router bits
Leg storage panel (4) for convenient storage of
accessories
The table leg inserts must be installed before attaching
the tabletop.
1. Place the table leg insert (3 or 4) into the opening in
the table leg (2) so that it is positioned at the very top
of the opening.
2. Press the insert in so that it is completely flush with
the leg.
3. Push the insert down as far as it will go to lock it
in place.
Fig. 1
TOOLS REQUIRED (not included}
Phillips screwdriver
Small-sized adjustable wrench
Tape with adhesive backing (optional)
ROUTER TABLE LEGS
(FIG. 2)
1. Insert eight 1/4-20 x 11½in. long carriage bolts (H)
through the router tabletop (1) as shown in Fig. 2.
2. Assemble the legs (2) to the router table as shown
in the figure.
3. Assemble a 9/32 in. ID x 5/8 in. OD in. x 1/16 in. thick
washer (D) and a 1/4-20 KEPS nut (C) onto each of
the bolts.
4. Securely tighten the fasteners.
NOTE: It may be easier to assemble the legs by
laying the router table on its front or back, or by using
adhesive tape over the carriage bolt heads to hold
them in place and turning the router table upside down.
Fig. 2
©
12