The Switch To The Fascia Fig - Craftsman professional 171.61181 Manual Del Propietário

ATTACH THE SWITCH TO THE FASCIA
(FIG. 3)
1. Align the two outermost holes on the top of the switch
assembly (6) with the holes in the front fascia panel
(5), as shown in Fig. 3.
2. Insert two #10-32 KEPS nuts (A) into the hex-shaped
recesses in the back of the switch assembly (6),
toothed side out, and secure the switch to the fascia
panel with two #10-32 x 3/4 in. truss-head machine
screws (G) while holding the KEPS nuts in place in
the recess with your finger.
Fig. 3
ATTACH THE SWITCH/FASCIA ASSEMBLY TO
THE ROUTER TABLE
(FIG. 4)
NOTE: The fascia assembles to the inside of both the
table legs and the router tabletop.
1. Line up the holes on the fascia panel with the holes
in the table legs and the two slots on the front of the
router tabletop.
2. Attach the fascia panel to the router table top using
two #10-32 x 3/4 in. truss-head machine screws (G)
and two #10-32 KEPS nuts (A), toothed side out, as
shown in Fig. 4.
3. Attach the fascia to the legs using four #10-32 x
3/4 in. truss-head machine screws (G) and four #10-32
KEPS nuts (A), toothed side out, as shown in Fig. 4.
4. TIGHTEN all screws SECURELY.
Fig. 4
13