Important Safety Information - Craftsman professional 171.61181 Manual Del Propietário

f
! ONE-YEAR FULL WARRANTY ON CRAFTSMAN PROFESSIONAL TOOL
If this Craftsman tool fails due to a defect in material or workmanship within one year from the date
of purchase, CALL 1-800-4-MY-HOME _ TO ARRANGE FOR FREE REPAIR (or replacement if repair proves
impossible).
This warranty does not include expendable parts, such as lamps, batteries, bits or blades.
This warranty gives you specific legal rights, and you may also have other rights which vary
from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 _j
iMPORTANT SAFETY iNFORMATiON . .. 2=6
Optional Router Table Accessories ...... 7
Parts List ......................... 8-11
Router Table Assembly ............. 12-21
Router Table Operation ............ 22=33
I-_ I Read and understand the tool manual and these instructions for the use of this table with
WARNING
your router. Failure to follow all instructions listed below may result in serious personal injury.
SAVE THESE iNSTRUCTiONS
Work Area
Keep your work area clean and well lit. Cluttered
benches and dark areas invite accidents.
Do not operate power tools in explosive
atmospheres, such as in the presence of flammable
liquids, gases, or dust. Power tools create sparks which
may ignite the dust or fumes.
Keep bystanders, children, and visitors away while
operating a power tool. Distractions can cause you to
lose control.
Electrical Safety
Grounded tools must be plugged into an outlet
properly installed and grounded in accordance
with all codes and ordinances. Never remove the
grounding prong or modify the plug in any way. Do
not use any adaptor plugs. Check with a qualified
electrician if you are in doubt as to whether the outlet
is properly grounded, if the tools should electrically
malfunction or break down, grounding provides a low
resistance path to carry electricity away from the user.
Improper grounding can shock, burn, or electrocute.
Grounded tools are equipped with three-conductor cord
and three-prong type plugs. Before plugging in the tool,
be certain the outlet voltage suppfied is within the voltage
marked on the nameplate. Do not use "AC only" rated
tools with a DC power supply.
Double-insulated tools are equipped with a polarized
plug (one blade is wider than the other.) This plug will
fit in a polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install a
polarized outlet. Do not change the plug in any way.
Double Insulation [] eliminates the need for the three-
wire grounded power cord and grounded power supply
system. Before plugging in the tool, be certain the outlet
voltage suppfied is within the voltage marked on the
nameplate. Do not use "AC only" rated tools with a DC
power supply.
Avoid body contact with grounded surfaces such
as pipes, radiators, ranges, and refrigerators.
There is an increased risk of electric shock if your body is
grounded, if operating the power tool in damp locations
is unavoidable, a Ground Fault Circuit interrupter must be
used to supply the power to your tool. Electricians'
rubber gloves and footwear will further enhance
your personal safety.
Don't expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of
electric shock.
Do not abuse the cord. Never use the cord to carry
the tools or pull the plug from an outlet. Keep cord
away from heat, oil, sharp edges, or moving parts.
Replace damaged cords immediately. Damaged cords
increase the risk of electric shock.
When operating a power tool outside, use an outdoor
extension cord marked "W-A" or "W." These cords are
rated for outdoor use and reduce the risk of electric
shock. Refer to "important information About Extension
Cords" in your router table manual.