Making Ice; Control Panel - Caterlite CN861 Manual De Instrucciones

Ocultar thumbs Ver también para CN861:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
UK
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging and
remove the protective film from all surfaces.
2. When positioning the ice maker, maintain
a distance of 20cm (7 inches) between the
appliance and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
3. If necessary, adjust the screw legs of the ice
maker to make it level. The efficiency of the
ice maker can be reduced if the appliance is
unevenly located.
Operation

Control Panel

LARGE ice cube indicator
ADD WATER indicator
SMALL ice cube indicator
ICE FULL indicator
4
CN861_ML_A5_v2_20180918.indb 4

Making Ice

Each time the appliance is refilled, the first
ice making cycle is used to reduce the water
temperature. This results in uneven ice cube
production which is perfectly normal. You may wish
to discard ice created in the first two production
cycles.
1. Lift the access lid and fill the water tank up the
level of the ice basket shelf.
2. Connect the appliance to the power and press
the POWER button.
3. Press the SELECT button repeatedly to scroll
through the ice cube sizes. Stop when the
required size is illuminated.
SELECT button
4. The appliance will run a start-up routine and
then begin ice production.
SELECT
POWER
POWER button
5. When the cubes reach the ice sensor the
appliance will stop production. Production
resumes once ice has been removed.
Note: Before using for the first
time, clean the water tank, ice
basket and ice basket shelf. Use
the first 3 ice making cycle to
flush out the system. Discard
the water and ice created from
the first 3 cycles.
Note: The ice making cycle will
vary depending on the size of
cube selected. Larger cubes will
take longer to produce.
Note: If the water level is too
low, the ADD WATER indicator
lights up and the appliance
stops working. Fill the water
tank and the appliance will
restart automatically.
2018/9/18 16:23

Publicidad

Tabla de contenido
loading

Tabla de contenido