Publicidad
Idiomas disponibles
Idiomas disponibles
WHEN USING HIGH PRESSURE INFLATOR TO INFLATE VEHICLE TIRES, BICYCLE TIRES, ATV TIRES,
SPORTS BALLS, ETC.
1. Remove 2 IN 1 All Purpose Inflator from carrying bag and place evenly on flat surface.
2. Remove the 12 Volt power cord from pouch located inside the carrying bag.
3. Plug the Power Cord Inlet Plug into the Power Cord Plug-In Outlet located on the side of the All
Purpose Inflator body. (Please see image #1 below).
4. Insert the 12 Volt power cord plug into your vehicle's 12 Volt DC power outlet. (Please see image #2
below).
5. Connect the Quick Connect Valve Adaptor to tire air valve by pushing the valve lever down until it is
securely attached to the tire air valve. (See NOTE below).
6. Turn the inflator on by pushing the in-line On/Off power switch to the "I" position. Monitor the PSI on the
pressure gauge to fill your item to desired air pressure.
7. Once you have reached the desired air pressure, move the On/Off power switch to the "O" position.
8. Remove the air hose from the tire by lifting up on the valve lever. You will then easily lift the valve lever
upward and it will easily release from the valve you were inflating.
9. Remove the 12 Volt power cord from the DC 12 Volt power outlet.
10. If necessary allow unit to cool before putting back into the carrying bag.
11. Store the 12 Volt power cord in the pouch inside the carrying bag.
NOTE: To inflate other objects, attach desired accessory to Quick Connect Valve Adaptor. Sports needle and
presta valve adaptor store conveniently in the built-in storage compartment of the inflator. See inflator parts
diagram on page 4.
Image #1
ALL PURPOSE INFLATOR OPERATING INSTRUCTIONS
DO NOT OVER-INFLATE ITEM BEING INFLATED. FOLLOW MANUFACTURERS
SUGGESTED PSI LEVELS ON ITEM YOU ARE INFLATING.
Image #2
5
Publicidad
