Publicidad
Idiomas disponibles
Idiomas disponibles
WHEN USING HIGH VOLUME INFLATOR TO INFLATE AIR MATTRESSES, RUBBER RAFTS, BEACH
TOYS, ETC.
Note: Your High Volume Inflator is a great device for inflating or deflating air mattresses, small boats,
inflatable toys and a host of other items that use a large volume of low pressure air.
The High Volume Inflator comes with three nozzles of varying sizes to fit most air valves on high volume
inflatables.
To Inflate:
1. Remove 2 IN 1 All Purpose Inflator from carrying bag and place evenly on flat surface.
2. Remove High Volume Inflator from built-in compartment. (Please see image #3 below).
3. Remove the 12 Volt power cord from pouch located inside the carrying bag.
4. Plug the Power Cord Inlet Plug into the Power Cord Plug-In Outlet. (Please see image #4 below).
5. Insert the 12 Volt power cord plug into your vehicle's 12 Volt DC power outlet. (Please see image #5
below).
6. Select the correct size inflation nozzle, depending on the item you are going to inflate, and attach to the
port on the High Volume Inflator marked "Inflation Port".
Note: The 3 inflation nozzles fit onto each other/stack on top of each other so as to give the correct air
tight fit.
7. Turn the inflator on by pushing the in-line On/Off power switch to the "I" position.
8. Once you have reached the desired air pressure on the item you are inflating, move the On/Off power
switch to the "O" position.
9. Remove the 12 Volt power cord from the DC 12 Volt power outlet.
10. Remove the nozzle (s) from the High Volume Inflator and store inside built-in compartment.
11. Return High Volume Inflator to its built-in compartment.
12. Store the 12 Volt power cord in the pouch inside the carrying bag.
13. Store your 2 IN 1 All Purpose Inflator in the carrying bag.
To Deflate:
If you wish to deflate, follow the same procedure as above using the outlet that is marked "Deflation Port"
1.
on your High Volume Inflator.
Image #3
ALL PURPOSE INFLATOR OPERATING INSTRUCTIONS
DO NOT OVER-INFLATE ITEM BEING INFLATED. FOLLOW MANUFACTURERS
SUGGESTED PSI LEVELS ON ITEM YOU ARE INFLATING.
Image #4
6
Image #5
Publicidad
