About the ntro,
ls on the Air Conditioner
The controls will look like one, of the following.
®
®
POWER BU_ON
To turn the air conditioner ON, push the bu_on. To turn the air conditioner OFF, push the button again.
This button takes priority over _y other buttons.
OPERATION MODE SELECTION BU_ON
Everytime you push this button, it will toggle COOL, FAN and DRY.
ON/OFF TIMER BU_ON
Everytime you push this button, timer is set as follows.(1 Hour _ 2Hours. _ 3Hours e 4Hours
5Hours e 6Hours e 7Hours .e 8Hours .e 9Hours .e 10Hours .e 11Hours ,.-) 12Hours .e Cancel)
FAN SPEED SELECTOR
Everytime you push this button, it is set as follows. (Hi[ F3 ] e Low[ _ I ] -_ Med[ F2 ] .e Hi[ _3 ]..--)
ROOM
TEMPERATURE
SETTING BU_ON
This button can automatically' control the temperature of the room. The temperature can be set
within a range of 60_ to 86_ by 1°F,
Select the lower number for lower temperature of the room_
AUTO SWING
This button can automatically control the air flow direction_
ENERGY SAVER
The fan stops when the compressor stops cooling.
Approximately every 3 munutes the fan wi!l turn on and check the room _r to determine if cooling is n_ded.
REMO,CON SIGNAL RECEIVER
When the air conditioner
has been performed
its cooling operation
and is turned off or set to
the fan position,
wait at: least 3 minutes before resetting
to the cooling operation
again.