INSTALLATION
EMBER FIBER INSTALLATION
NOTE: This is an optional accessory, and is not required for operation of the heater.
WARNING: Apply loose material per instruction manual. DO NOT apply extra material
or material not supplied with the heater. Replace only with Pleasant Hearth brand Ember
Flakes (Model #GEF100, GEF100L).
WARNING: All previously applied loose material must be removed prior to reapplication.
WARNING: This appliance includes a material to simulate glowing embers when the unit is
in operation. Positioning this material is critical to the safe operation of the unit and directions
for the size and placement must be followed explicitly.
1. Open the small bag and remove all of the ember material.
2. Tear the material into rectangular shapes approximately 1/2" Long x 3/16" Wide x 1/16" Thick.
Work the material until it is loose and fluffy.
3. Carefully place the shapes on the horizontal burner tube as depicted in Fig. 25.
4. Place the Ember Flakes around edges of the Burner Port Holes. Make sure the Ember Flakes do
not fully cover the Burner Port Holes.
5. Flames emanating from the Burner Port Holes will cause the ember Flake edges to glow when the
unit is in operation.
Fig. 25
(Approx. 1/2" long x 3/16" wide x 1/16" thick)
Ember Flake
Ember Flake Positioning
25
A
Burner Port Holes
Ember Burner Tube