Poulan Pro PP136 Manual De Instrucciones página 10

If theunit s tilldoesn't start, r efer t o
TROUBLESHOOTING TABLE or call
1-800-554-6723.
OPERATING THE COUPLER
This model is equipped with a coupler which
enables optional attachments to be installed.
The optional attachments are:
MODEL:
Edger ....................... PP1OOOE
Cultivator .................... PP2000T
Blower ...................... PP3000B
Brushcutter .................. PP4000C
Pruner ...................... PP5000P
WAR NIN G: Always stop unit and dis-
connect spark plug before removing or instaF
ling attachments.
REMOVING TRIMMER ATTACH-
MENT (OR OTHER OPTIONAL AT-
TACHMENTS)
CAUTION: When removh_g or installing at-
tachments, place the unit on a flat surface for
stability.
1. Loosen the coupler by turnh_g the knob
counterclockwise.
Upper Shaft
Coupler
Lower \
Attachment
TIGHTEN Knob
Press and hold the locking/release button.
Locking/Release
Button
Coupler Primary Hole
Guide Recess
Upper Locking/ Attachment
Shaft Release
Button
w_WARNING:
Make sure the locking/
release button is locked in the primary hole
and the knob is securety tightened before op-
erating the unit. All attachments are designed
to be used in the primary hole unless otherwise
stated in the applicable attachment instruction
manual Using the wrong hole could lead to seri-
ous injury or damage to the unit.
Secondary Hole
Locking/Release
Button in Primary Hole
OPERATING INSTRUCTIONS
It is recommended that the engine not be
operated for longer than 1 minute at full
throttle.
OPERATING POSITION
ALWAYS WEAR:
Eye Protection
Lower Attachment
3. While securely holding the engine and
upper shaft, pull the attachment straight
out of the coupter.
INSTALLING OPTIONAL ATTACH-
MENTS
1. Remove the shaft cap from the attach-
ment (if present).
2. Position locking/release button of attach-
ment into guide recess of coupler.
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4. Before using the unit. tighten the knob se-
curely by turning clockwise.
Long Pan%
Heavy SI
Cut from your left to your right. _'-'-
A
WARN IN G: Alwayswear
eye protec-
tion. Never lean over the trimmer head.
Rocks or debris can ricochet or be thrown into
eyes and face and cause blindness or other
serious injury.
Do not run the engine at a higher speed than
necessary. The cutting line will cut efficientIy
when the engine is run at less than full throttle.
At lower speeds, there is less engine noise
and vibration. The cutting line will last longer
and will be less likely to "weld" onto the spool.
Always release the throttle trigger and allow the
engine to return to idle speed when not cutting.
10