Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
THE
LINE
1.
Remove
spool
by firmly
pulling
on tap
button.
2.
Clean entire surface
of hub and spool.
3.
Replace with a pre-wound spool, or cut two
lengths of 12-1/2 feet of 0.080" (2 mm) di-
ameter Poulan PRO brand line.
_WARNING:
Never
use wire, rope,
string, etc., which can break offand
become a
dangerous
missile.
4.
Insert ends of the lines about 1/2 inch (1
cm) into the small holes on the inside of
spool.
/i
Roles
Line exit holes
Line in Notch
\
Line in Notch
Hub
5.
Wind the line evenly and tightly
onto the
spool. Wind in the direction
of the arrows
found on the spool.
6.
Push the lines into the notches,
leaving 3
to 5 inches (7 - 12 cm) unwound.
7.
Insert the lines into the the exit holes in
the hub as shown in the illustration.
8.
Align the notches with the line exit holes.
9.
Push
spool
into hub until it snaps
into
place.
10. Pull the lines extending outside ofthe hub
to release the lines from the notches.
REPLACING
THE
CUTTING
HEAD
1.
Align hole in the dust cup with the hole in
the side of the gearbox
by rotating the
dust cup.
2.
Insert a small screwdriver
into aligned
holes. This will keep the shaft from turn-
ing while removing
and installing trimmer
head.
Screwdriver
_t_
3.
While holding the screwdriver
in position,
remove
trimmer
head by turning
clock-
wise.
4.
Thread
replacement
trimmer
head onto
the shaft by turning
counterclockwise.
Tighten until secure.
5.
Remove
the screwdriver.
CARBURETOR
ADJUSTMENT
_il WARNING:
Keep
others away when
making idle speed adjustments.
The trimmer
head will be spinning
during most of this pro-
cedure,
Wear your protective
equipment
and
observe
all safety precautions.
After making
adjustments,
the
trimmer
head
must
not
move/spin
at idle speed,
The carburetor
has been carefully
set at the
factory, Adjustments
may be necessary
if you
notice any of the following
conditions:
• Engine
will not
idle when
the throttle
is
released.
• The trimmer
head moves/spins
at idle.
Make adjustments
with the unit supported
so
the cutting
attachment
is off the ground
and
will not make contact
with any object.
Hold
the unit by hand while running and making ad-
justments.
Keep all parts of your body away
from the cutting attachment
and muffler.
Idle Speed
Adjustment
Allow engine to idle. Adjust speed until engine
runs without trimmer head moving or spinning
(idle too fast) or stalling
(idle speed too slow).
• Turn
idle
speed
screw
clockwise
to
increase
engine
speed
if engine
stalls or
dies.
• Turn idle speed screw counterclockwise
to
decrease
engine
speed
if trimmer
head
moves
or spins at idle.
Ag&WARNING:
Recheck
the idle speed
after
each adjustment,
The trimmer
head
must not move or spin at idle speed to avoid
serious
injury to the operator
or others.
Air Filter
__
Cover
-_
Idle Speed
Screw
If you require further assistance
or are unsure
about performing
this procedure,
contact
an
authorized
service
dealer
or
call
1-800-554-6723.
13
Publicidad
