LEITZ iLAM TOUCH 2 A3 Instrucciones De Uso página 6

EN
Instruction Manual
How to use the Smart Guide System 4
( Turbo models only )
1. Open the guides J.
2. Pull out the supports K.
3. Open the pouch and place it on the input tray D.
4. Close the guides J. Add the document on top of the
lower pouch sheet and supports K.
5. Close the pouch. Feed the pouch into the laminator
A.
Notice: If possible avoid the use of the reverse
button G when using the Smart Guide System.
However, should use of the reverse button G be
essential, ensure you hold the pouch away from the
feed sensor once it has exited, and carefully remove
from the Smart Guide System.
'Auto Shut-off' function
If the machine is not active for 30 minutes, the Auto
Shut-off function will place the machine into standby
mode. To operate the machine, press any button or
cycle the power switch.
6
Maintenance and care
How to clean the rollers 5
In order to remove superfluous adhesive from inside
the device, clean the rollers regularly.
1. Set the rear switch F in the "I" position to turn on the
laminator. The On/Off button H will light blue and
you will hear a beep.
2. Press the On/Off button H. The On/Off button H will
start flashing blue. The laminator heats up. As soon
as the On/Off button H lights steadily blue again
and you hear beep, the working temperature has
been reached.
3. Fold a sheet of unused copying paper once in the
middle.
4. Insert the paper with the folded side first into the
input tray 3–5 times. Alternatively insert a purpose
designed cleaning card into the machine.
How to clean the housing
1. Pull out mains plug B and wait for the device to cool
down.
2. Wipe the exterior with a soft, damp cloth and a
dishwashing detergent. Do not use cleaning tissues
or chemical substances which might damage the
surface.
How to retrieve a pouch that has not been
inserted correctly 6
1. Press and hold the reverse button G. The pouch is
driven out again at the input tray.
2. Assist the reverse motion by carefully pulling at
the pouch. The reverse motion ends once a full A3
length has been ejected. Then the machines returns
to forward feed mode.