Publicidad
Idiomas disponibles
Idiomas disponibles
Installation - Wired Application
1
Verifying the transformer
power rating
Power must be supplied from a 16 volt AC transformer
with a 10 watt or greater rating.
To test the transformer output, see Troubleshooting,
page 10.
WARNING: This doorbell base requires a low voltage
electrical connection. Do not connect directly to 120V AC.
2
Labeling wires and removing
the existing doorbell base
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the doorbell base.
□
Remove the cover from the existing doorbell base
and label all wires with masking tape before
disconnecting:
□
"F" - Front door push button wire
□
"T" - Transformer wire
□
"R" - Rear door push button wire (if
applicable)
3
Mounting the doorbell base
□
Remove the doorbell base (B) from the doorbell
cover (A). The doorbell cover (A) is press fitted
to the doorbell base (B).
□
Route the wires through the wire entrance
hole (1) in the doorbell base (B).
□
Using the "UP" arrow indicator, place the
doorbell base (B) against the wall and mark
the four screw hole locations.
□
Drill four 7/32 in. pilot holes and insert wall
anchors (BB).
□
Attach the doorbell base (B) to the mounting
surface using the four screws (AA) and tighten
securely.
NOTE: DO NOT install batteries if connecting doorbell
base to transformer wires.
Not included
□
Disconnect all wires from the existing doorbell
base and remove doorbell base from mounting
surface.
F R
T R
R E
5
Please contact 1-866-308-3976 for further assistance.
T
O N
T
O N
F R
S
S
A N
A N
T R
A R
R E
A R
AA
B
SYNC – PRESS
AND RELEASE.
RESET – HOLD
10 SECONDS.
TUNE – HOLD
FRONT TRANS REAR
1 SECOND.
1
HOMEDEPOT.COM
Publicidad
