Preparations; Before First Use; Setting Up The Appliance - Silvercrest SSC 200 A1 Instrucciones De Uso

Preparations

Before first use
Before the first use, you should thoroughly clean all parts to remove any produc-
tion residues. Proceed as described below:
Clean all parts as described in the section "Cleaning".
Place the appliance base 3 on a level, stable and heat-resistant surface
close to an easily accessible power outlet.
Insert the ceramic pot 2 into the appliance base 3.
Make sure that the dial is set to " " and plug the power plug into a wall
outlet.
Fill the ceramic pot 2 with 0.5 litres of water.
Place the glass lid 1 on the ceramic pot 2.
Set the dial 5 to "
heat up.
NOTE
► During initial use, a small amount of smoke and a slight odour may occur
due to production residue. This is normal and dissipates after a short time.
Ensure sufficient ventilation, for example, by opening a window.
Switch off the appliance after 60 minutes by turning the dial 5 back to " ".
Remove the plug from the mains power socket.
Allow the appliance to cool down sufficiently, pour the water away and clean
all parts again as described in the section "Cleaning".

Setting up the appliance

NOTE
► If you are using the appliance for the first time, proceed as described in the
section "Before first use".
Place the appliance base 3 on a level, stable and heat-resistant surface
close to an easily accessible power outlet.
Insert the ceramic pot 2 into the appliance base 3.
Make sure that the dial is set to " " and plug the power plug into a wall
outlet.
The appliance is now ready for use.
SSC 200 A1
". The control lamp 4 lights up, the appliance starts to
GB │ MT │
53 ■