Velleman CAMCOLD26 Manual Del Usuario página 5

6. Hardware installation
Refer to the illustrations on page 2 of this manual.
1. Choose a location for the camera, keeping following guidelines in
mind:
o do not install the camera in locations where extremely high or
low temperatures or excessive vibrations may occur.
o avoid mounting the camera near high electro-magnetic fields.
o do not aim the camera at the sun or other extremely bright
objects or reflections (e.g. metal doors).
2. Hold the mounting plate [1] and unscrew the fixation ring [2] by
turning it counter-clockwise. Note that the lens enclosure [5] and
positioning ring [3] are also released.
3. Use the mounting plate [1] to determine the position of the
mounting holes. Drill the holes.
4. Guide the power and video cable [11] through one of the cable
slots [10] and fix the mounting plate [1] on the ceiling or wall
with the four screws.
5. Position the positioning ring [3] over the lens enclosure [5] onto
the mounting plate [1] and then fix the ensemble by screwing
the fixation ring [2] onto the mounting plate [1]. Make sure the
fixation ring is not screwed too tight to leave the option open to
position the lens into the direction of the desired field of
operation.
6. Connect the video connector [A] to a monitor (not incl.) or a
sequential switcher/quad splitter (not incl.) in case of multiple
domes.
7. Connect the power connector [B] to a 12 VDC power supply (not
incl.).
8. Set up the desired field of observation by adjusting the position of
the lens enclosure [5] in the positioning ring [3].
9. Manually adjust the zoom [4] and focus [8] with their screws.
The location of the screws can be determined by looking at the
position of the light sensor [9].
10. Tighten the fixation ring [2] to secure the camera's position.
V. 01 – 09/01/2015
CAMCOLD26/CAMCOLD26W
5 ©Velleman nv