Velleman CAMCOLD26 Manual Del Usuario página 6

7. OSD Settings
7.1 Control Buttons
There is a small joystick in the camera cable that allows you to
adjust the settings of the camera using an on-screen display (OSD).
In the OSD menu:
 NEXT/BACK: select this option and press the button to go to the
next/previous page of options in the menu.
 RETURN: select this option and press the button to return to the
previous level in the menu.
 EXIT: select this option and press the button to leave the OSD
menu without saving the settings.
 SAVE&EXIT: select this option and press the button to save all
settings.
 LOAD DEFAULT: select this option and press the middle button to
reset the camera to the factory defaults.
 SOFT VERSION: displays the version number of the camera
software.
The OSD menu settings are described in detail below.
7.2 Noise Reduction
Use this function to switch 3D noise reduction on or off.
Menu: IMAGE > 3D-NR
Select ON to activate 3D noise reduction; select OFF to deactivate.
V. 01 – 09/01/2015
CAMCOLD26/CAMCOLD26W
 Press and hold the button during
± 2 seconds to access the menu, or press
briefly to select an option.
 Press the button upward and downward to
move up and down in the menu.
 Press the button to the left and to the right
to modify the menu parameters.
6 ©Velleman nv