Publicidad
Idiomas disponibles
Idiomas disponibles
This unit can be started with an optional electric start accessory
(items sold separately). Refer to the electric start accessory
operator's manual for the proper use of this feature.
Please contact your local retailer, call the Customer Support
Department or visit our website for more information.
STARTING INSTRUCTIONS
NOTE: This unit includes a cruise control, which allows the operator
to maintain the desired engine speed without having to squeeze
the throttle control.
1. Mix gasoline with oil. Refer to Oil and Fuel Mixing Instructions.
2. Fill the fuel tank. Refer to Fueling the Unit.
NOTE: There is no need to turn the unit on. The On/Off switch is in
the On ( I ) position at all times (Fig. 7).
3. Slowly press and release the primer bulb 10 times (Fig. 8). If fuel
cannot be seen in the primer bulb, press and release the primer
bulb until fuel is visible.
4. Move the choke lever to Position 1 (Fig. 8).
5. Move the cruise control to the HI (fast) position (Fig. 7).
NOTE: Keep the cruise control in the HI (fast) position for ALL
further steps.
6. Crouch in the starting position (Fig. 9).
7. Insert the electric start accessory into the electric start port (Fig. 10).
Refer to the Operation section of the electric start accessory
operator's manual.
8. Run the electric start accessory for 2 seconds.
9. Move the choke lever to Position 2 (Fig. 8).
10. Run the electric start accessory in intervals no longer than 2
seconds each until the unit starts.
11. Remove the electric start accessory from the unit.
12. Allow the engine to warm up for 30 to 60 seconds.
13. Move the choke lever to Position 3 (Fig. 8). Allow the engine to
warm up for an additional 60 seconds. The unit may be used
during this time.
NOTE: The engine is properly warmed up when it accelerates
without hesitation.
NOTE: Once the engine is properly warmed, the cruise control may
be adjusted and the throttle control can be used normally.
14. Put on the harness. Refer to Using the Harness.
IF... the engine hesitates, return the choke lever to Position 2 (Fig. 8)
and continue the warm-up.
IF... the engine does not start, begin the starting procedure with step 3.
IF... the engine fails to start after a few attempts: Move the choke
lever to Position 3. Move the cruise control to the HI (fast)
position. Run the electric start accessory in intervals no longer
than 2 seconds each until the unit starts.
IF... the engine is already warm, begin the starting procedure with
step 8.
USING THE ELECTRIC START ACCESSORY
ELECTRIC START ACCESSORIES
Item No.
49MASCBP912 . . . . . . . . . . . . . . . . . . . . . . . . . . . .Engine Starter Bit
49MRBESY912 . . . . . . . . . . . . . . . . . . . . . .Cordless Electric Starter
STOPPING INSTRUCTIONS
1. Release the throttle control, or move the cruise control to the LO
(slow) position, and allow the engine to idle.
2. Press and hold the On/Off switch in the Off (O) position until the
engine comes to a complete stop (Fig. 7).
11
Description
Electric Start Port
Fig. 10
Publicidad
