Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHART:
See appropriate
section
in manual unless directed to Sears service
center
PROBLEM
CAUSE
CORRECTION
Engine
overheats
1. Low oil level/dirty
oil.
2.
Dirty engine
air screen.
3.
Dirty engine.
.
2.
3.
Check
oil level/change
oil.
Clean
engine
air screen.
Clean cylinder fins, air
screen, muffler area.
Remove and clean muffler.
Adjust carburetor to richer
position.
4.
Partially plugged
muffler.
4.
5.
Improper
carburetor
5.
adjustment.
Excessive
1. Ground
too dry and hard.
1. Moisten
ground or wait for
bounce/difficult
more favorable
soil condi-
handling
tions.
Soil balls up or
1. Ground too wet.
1. Wait for more favorable
clumps
soil conditions.
Engine runs but
1. Tine control is not
1.
Engage tine control.
tiller won't
engaged.
move
2. V-belt not correctly
2.
Inspect]adjust
V-belt.
adjusted.
3. V-belt is off pulley(s).
3.
InspectV-belt.
Engine runs but
1. Tilling too deep.
1.
Set depth stake for shallower
labors when
tilling.
tilling
2. Throttle control
not
2.
Check throttle
control setting.
properly adjusted.
3.
Carburetor
out of
3.
Make necessary adjust
adjustment,
ments.
TinesSkip
1. Shear pin (s) broken.
1. Replace
shear pin(s).
over ground
Hard to Shift
1. Gears not timmed.
1. Briefly engage
drive control
into gear
bar and release or rock tiller
forward
and backward
until
are able to shift gears.
1.
Tiller shuts off
when drive
control bar
engaged
.
1. Shift lever set in between
counter rotating till posi-
tion and forward
rotating
till position.
2. Tines jammed.
Shift to either counter
rotating till position or
forward
rotating
till position.
Clear tines.
21
Publicidad
