avide ABLS12V160160-60RGBW Manual Del Usuario

ABLS12V160160-60RGBW
EN DE HU RO SK CZ HR SI SRB PT LT PL GR IT ES FR BG
Thank you for choosing AVIDE product! Please read the following instructions carefully before use.
Prior to assembly, check the LED strip integrity. Do not use the product in case of damage! Switch off the
power supply before installation! When assembling, make sure that the cables are connected correctly.
Do not use the LED strip wrapped or rolled up! We do not accept any liability for non-compliance with the
rules of life and accident protection, or for possible damage resulting from incorrect installation or
damage to the products.
Before installation, please clean the surface where the strip will be installed.
Remove the protective layer and apply the strip. Gently press the strip to the mounting surface until
tightly glued (do not press LEDs, resistors, and controls). The surface where the strip is glued must be solid
and without breaks to avoid damages to the strip.
Please read the product information and check the electrical parameters of the LED strip and the power
supply and controller. For 12V LED strip, use only 12V power supply and controller!
The LED strip has 160 mm of cut and solder points. Soldering and cutting is possible at these contact
points. Before soldering, the silicone layer must be carefully removed from the soldering points! When
soldering, make sure that the polarity is correct: "+" indicates positive "- " indicates negative polarity.
Possible installation:
Power supply
160mm
Input
LED CONTROLLER
+
R
G
B
W
Output