Publicidad
Idiomas disponibles
Idiomas disponibles
EN
• Do not hang anything above or in front of the unit.
• The unit may be operated in the upright position only.
• Do not use the unit near a shower, bathtub, sink, or swimming pool.
• Do not use the unit in a wet or dusty environment.
• Do not use the unit in an environment where explosive gases or flammable
substances (solvents, varnishes, adhesives, etc) are present.
• Pull the power cord out of the socket before assembly or disassembly of
the unit.
• Switch the unit off and pull the plug from the socket prior to cleaning and
after use of the unit.
• Keep the unit clean; prevent foreign bodies from entering the mesh
openings. These could cause serious injury, short circuit, damage or fire
of the unit.
• Do not use abrasive or chemically aggressive substances to clean
the unit.
• Never use the unit if the power supply cord or plug is damaged. Have
any defects immediately repaired by an authorized service center.
• Do not use the unit if it does not operate properly, or if it has been
dropped, damaged or exposed to liquid. Take the unit to an authorized
service center for testing and repair.
• The unit is not designed for outdoor use.
• The unit is intended for household use only; it is not designed for
commercial application.
• Do not touch the unit if your hands are wet.
• Do not immerse the power cord, plug, or unit in water or any other
liquid.
• Do not attempt to repair the unit by yourself. Contact an authorized
service center for repair.
• This appliance may be used by children 8 years of age and older and by
persons with physical or mental impairments or by inexperienced persons
if they are properly supervised or have been informed about how to use
of the product in a safe manner and understand the potential dangers.
Children must not play with the appliance. This appliance may be cleaned
by children 8 years of age and older if they are properly supervised. Keep
this appliance and the power cord out of reach of children younger than
8 years of age.
Failure to follow the manufacturer's instructions may lead to refusal of warranty repair.
34
PRODUCT DESCRIPTION
1. Front wire mesh
2. Nut
3. Fan
4. Mesh attachment nut
5. Rear wire mesh
1
6
ASSEMBLY
ATTENTION!
Pull the power cord out of the socket before assembling or disassembling the unit.
The fan may only be used with the front and rear protective mesh attached (1), (5).
1. Mount the unit body unit onto the support stand.
2. Position the rear protective mesh (5) onto the drive unit so that the pins on the unit correspond with the holes in
the mesh. Use the attachment nut (4) to secure the assembly.
3. Slide the fan (3) onto the motor shaft by positioning the grooves in the fan hub against the shaft tongues.
4. Turn the nut (2) counter-clockwise to fasten the fan.
5. Position the front wire mesh so that the mesh edges fit into the grooves on the inside of the ring.
6. Tighten the fastening ring with the screw.
VS504x
VS504x
6. Unit body
7. Stand
8. Mode selector
9. Oscillation selector
2
3
4
5
7
EN
9
2
8
6
1
35
Publicidad
