PLAYKIN BMW i4 1300024 Manual Del Usuario página 47

ATTACH THE REAR WHEELS
2
1 1
5
6
4
5
Remove all the parts from the front axle.
1. Slide a Ø10 washer onto the front axle.
2. Slide a wheel onto the front alxe.
3. Slide a Ø10 washer onto the front axle.
4. Tighten a lock nut to the end of the front axle with a spanner. DO NOT over tighten.
5. "Snap" the hubcap to the wheel.
Repeat the above procedure to assemble the other Front Wheel.
Remove all the parts from the rear axle.
1-2. Fit the wheel driver to the wheel. Insert and tigthen three Ø4x16 screws to
secure the wheel driver to the wheel.
3. Slide the wheel onto the rear axle (Left Side). Keep the wheel driver match up
with the gear box on the rear axle.
4. Slide a Ø10 washer onto the rear axle.
5. Tighten a lock nut to the end of the rear axle with a spanner.
Repeat the above procedure to assemble the other Rear Wheel.
HINT: An extra spanner has been provided to hold the Lock Nut on the other side
of the rear axle while tightening the Lock Nut on the other side.
6. Fit the hub caps to the wheels.
3
4
2
3
1
47
Rear gear boxes
Rear gear boxes
Front bottom view
EN